BRTYZGT04S2B
Product Introduction
The whole structure is driven by servo motor and RV reducer, which makes the operation more stable, more accurate and more efficient. Soup injection position, high stopping accuracy, single arm type soup, soup quantity fixed, the rate of defective products reduced. 2 Axis Die-casting Robot has high quality, simple operation and compact structure. It is driven by a full servo motor with fast response and high precision. The arm is driven by 0.75KW, and the maximum amount of soup is 4.5-6KG. It is suitable for operations in monotonous, frequent, dangerous and harsh environments.
Product parameter(specification)
|
Model |
Tablespoon Max |
Recommended height for smelter |
Recommended height for smelter arm |
Cycle Time |
Main control power |
Power Capacity |
Dimension |
|
BRTYZGT04S2B |
450mm |
≤1100mm |
≤500mm |
7.3s |
AC220V/50HZ |
1.67KVA |
1240*680*1250mm |
Automatic operation:
The manual-automatic switch, betting in the "automatic" position can be linked with the die-casting machine automatically to the soup machine operation.
(1) First to manually back to the soup surface detection position (detection rods touch aluminum material), the spoon immersed in aluminum soup preheat, or soup, note soup not less than three times, switch to "automatic" Start the action.
(2) Take the soup time timer After the internal timer, the spoon will rise to the drop position (too much aluminum material drops back to the furnace).
(3) Spoon timer in the drip timer is over, the spoon will restore the horizontal position.
(4)Arm forward, high and low speed automatic switching.
(5) The arm forward to the forward limit stop, while the soup spoon in the note at the same time the location of the soup, the timer backlash timer 16 seconds, the timer is finished before the die-casting machine finished mold injection Soup command signal occurs, Into the note soup action.
(6) When the injection limit is ON, the injection delay timer starts to count. When the timing is over, the injection signal is sent out to the die-casting machine. At the same time, the arm will move backwards.
(7) Arm back to the back low-speed limit (that is, standby position on the stove), soup spoon in the meter tilted state to the soup surface detection position, which will stop, take the soup time.
(8) Is operated by the cycle (1-7). However, if (4) the timing of the abnormal back-off timer is over, and the die-clamping machine is not received, the spoon arm will automatically retreat to the soup surface detection position, ) Cycle.
(9) After the positioning function to the soup machine: When the selected position after the soup machine, to the soup machine in the completion of step (3), will stop in the furnace standby, the timer starts timing until the start to receive the start signal (4); if the timer is finished, it has not received the start signal, the automatic back to the soup machine arm, to the soup noodle detection position, by the (2) Cycle of action.
WARNING: If "AUTO START" is selected for the machine, the switch will be switched to "AUTO" and the "SEND START" switch will be automatically switched back to the soup noodle at any position. Automatic cycle. (If the spoon is not preheated, please follow the steps (1) to complete the preheating and then the above action)
Hot Tags: 2 axis die-casting robot, China 2 axis die-casting robot suppliers, manufacturers, factory, Lightweight Arm Robot, 3 axis servo manipulator, Positioning Precise Robot, 2 Axis Die casting Robot, 5 axis Traverse Beam manipulator, Automatic Industrial Robot Arm