BRTIRUS1820A
Product descriptions:
Efficient general use six axis robot is a six-axis robot developed by BORUNTE for complex applications with multiple degrees of freedom. The maximum load is 20KG, the maximum arm length is 1850mm. Suitable for loading and unloading, injection machine, die casting, assembling, coating industry, polishing, detection etc. It is suitable for injection molding machine range from 500T-1300T. The protection grade reaches IP54 at the wrist and IP40 at the body. The repeat positioning accuracy is ±0.05mm.
Steps for replacing lubricating oil for wrist components of efficient general use six axis robot:
1) Returns the robot arm to zero point.
2) Turn off the power supply.
3) Remove the plug from the lubricating oil supply port on the wrist.
4) Remove the end of the wrist and drain the oil thoroughly.
5) Provide new lubricating grease through the lubricating oil supply port on the wrist until the lubricating oil cannot be injected.
6) Install the plug onto the lubricating oil supply port on the wrist.
7) Install the plug onto the lubricating oil outlet on the wrist.
Therefore, when there is need to add lubrication oil operations, please observe the following:
1. Slowly provide lubricating oil, and the oil supply speed should be controlled below 40cc/10 seconds. Do not use excessive force, and a lubricating oil gun with a clear amount of oil must be used. When there is no oil gun with a clear refueling amount, the refueling amount of the lubricating oil should be confirmed by measuring the changes in the weight of the lubricating oil before and after refueling.
2. If the oil supply does not meet the required amount, the gas can be supplied by using a precision regulator to extrude the gas from the chamber, and the air pressure should be controlled below a maximum of 0.025MPa using the regulator.
3. Use only the specified type of lubricating oil. If lubricants other than the specified type are used, it may damage the gearbox or cause other problems.
4. When installing the plug after oil supply, pay attention to wrapping tape and applying sealant to avoid oil leakage at the inlet and outlet.
5. To avoid accidents caused by slipping, excess lubricating oil should be thoroughly removed from the ground and the robot.
6. After supplying oil, follow the steps in item 3.4.4 to release residual pressure in the lubricating oil tank and install the plug. Pay attention to wrapping tape and applying thread sealant to prevent grease from leaking from the supply and discharge ports of efficient general use six axis robot.
Hot Tags: efficient general use six axis robot, China efficient general use six axis robot suppliers, manufacturers, factory, Efficient Intelligent Robot, Grab And Drag Robot, Medium Sized General Robot, Lightweight Arm Robot, High Speed Universal Robot, Super Long Arm Spread Robot