BORUNTE Industrial robot English （HC）instruction manual——Automatic Mode
The third gear knob to "automatic" into the automatic state is as follows:
In this interface, press the start button on the hand controller, the robot will start the movement to teach a good program.
Speed control enable: After checking, press the key speed deceleration key on the manual controller to adjust the speed.
Follow: Select the program to run after the step to which step the color will become dark.
Single-step mode: single-step operation in automatic mode.
Please refer to the following figure for the method of use:
Single-cycle mode: The program moves from the first step to the end of the module.
Cycle Time: The time taken by the entire program to go to the end of the module.
Cycle Display Button: Click this button 
to display the cycle time and the current cycle time. You can also view all counter count status, timer timing and stack parameter settings.
