BRTNG11WSS3PF
Product introduction:
Three axis servo injection manipulator series apply to all types of horizontal injection machine ranges of 250T-480T for take-out products. The vertical arm is the telescopic type with the product arm. Fewer signal lines, long-distance communication, good expansion performance, strong anti-interference ability, high repeatability of positioning, ability to simultaneously control multiple axes, simple equipment maintenance, and low failure rate are all advantages of the three-axis driver and controller integrated system.
Parts inspection procedures of three axis manipulator：
1) Confirmation of fixture function
A. Damage or filth on the suction cup
B. Whether the air pipe is leaky, broken, or loose.
C. The holding device's deviation or slackness. The holding plate may be damaged or distorted.
2) Inspect the machine parts for looseness, including the side posture group, the fixing screw, and the side posture group. If the fixture is crooked
3) Upkeep of bearing and guide rod lubrication
A. Clean the guide rod to get rid of dust and corrosion.
B. Use a brush to apply the lubricating oil evenly so that it doesn't build up easily.
Increasing attention of three axis servo injection manipulator:
1: Only licensed electricians should perform installations.
2: Turn off the power before beginning installation.
3. Mount on metal and keep away from combustible materials.
4. Check the safety connection to the ground.
5: The power supply is essential to the control system. Contractors should not be used to install controllers, transformers, or other AC accessories. Make sure your system has a dependable power source and protection.
6: Read the manual before beginning any installation, maintenance, or operation. Mechanical and electrical operators must be aware of the safety requirements.
7: The outside temperature is less than 50 degrees Celsius. Use is not permitted in cold or freezing temperatures.
Attention: Improper installation may result in a hazard, including equipment damage and bodily injury.
Features and functions of three axis servo injection manipulator:
Widely employed is the injection molding industry, which is particularly suitable for non-woven bags, suitcases, microwave oven lunch boxes, fresh-keeping boxes, disposable water cups, carpets, blankets, plastic brooms, artificial flowers, detergent bottles, cosmetic bottles, medicine bottles, and other common plastic products.
Hot Tags: three axis servo injection manipulator, China three axis servo injection manipulator suppliers, manufacturers, factory, High precision injection robot, High Precision Swing Arm Robots, High Speed Swing Arm Robots, swing arm manipulator, Pneumatic Manipulator, Industrial Swing Arm Robot for Injection Molding Machine