Borunte Robot Co., Ltd. is one of the most reliable manufacturers and suppliers of plastic injection moulding manipulator arm in China, also supports customized service with low price. Please feel free to wholesale advanced plastic injection moulding manipulator arm for sale here from our factory.
BRTV13WDS5P0F0
Product introduction:
plastic injection moulding manipulator arm applies to all types of horizontal injection machine ranges of 320T-700T for take-out products and sprue. The installation is different from traditional beam robots, products are placed at the end of injection molding machines. It has a double arm. The vertical arm is a telescopic stage and the vertical stroke is 1300mm. Five-axis AC servo drive. After installation, the installation space can be saved by 30-40%, and the plant can be used more fully allowing better utilization of production space.
Appearance and description of operation panel:
1. State Switch
The teaching pendant of plastic injection moulding manipulator arm includes three statuses, i.e. Manual, Stop, and Auto. [Manual]: Turn the state switch to the left to enter the Manual state [Stop]: Turn the state switch to the middle to enter the Stop state. In this state, parameters can be set. [Auto]: Turn the state switch to the middle to enter the Auto state. In this state, automatic and corresponding settings can be carried out.
2. Function Buttons
[Start] button:
Function 1: Press "Start" in Auto state and the manipulator will enter the automatic running state;
Function 2: Press "Origin" and then "Start" in Stop state, and the manipulator will return to the origin;
Function 3: Press "HP" and then "Start" in Stop state, and the manipulator will reset the origin;
[Stop] button:
Function 1: Press "Stop" in Auto state and the program will stop after the module ends. Function 2: When an alarm occurs, press "Stop" in Auto state to remove the alarm display that has been resolved.
[Origin] button: It is only applicable to homing actions. Please refer to Section 2.2.4 "Homing Method".
[HP] button: Press "HP" and then "Start, all axes will reset in the order of Y1, Y2 Z, X1 and X2, Y1 and Y2 will return to 0, and Z, X1 and X2 will return to the start position of the program.
[Speed Up/Down] button: These two buttons can be used to adjust the global speed in Manual and Auto state.
[Emergency Stop] button: In an emergency, pressing the "Emergency Stop" button will cut off the power of all axes, and the system will alarm "Emergency stop". After turning the knob out, press the "Stop" key to eliminate the alarm.
General function setting of plastic injection moulding manipulator arm:
In the status of STOP and AUTO, Press “FUNC” key to enter Function page, Use up/down key to move to each function, You can press STOP key to leave Function page and return Stop page.
Hot Tags: plastic injection moulding manipulator arm, China plastic injection moulding manipulator arm suppliers, manufacturers, factory, Industry Robot Arm for Injection Molding Machine, One Axis AC Servo Robot Arm, Large injection molding manipulator, General purpose 5 axis servo manipulator, Five axis Dual arm Manipulator, I M M ROBOT