BRTNG09WSS3PF
Product description:
Plastic injection molding robot mainly consists of three parts: the arm, the motion mechanism, and the control system. The arm is a component used to grasp work pieces (or tools), and there are various structural forms based on the shape, size, weight, material, and operational requirements of the object being grasped, such as clamping type, supporting type, and adsorption type. A motion mechanism that enables the hand to complete various rotations (swings), movements, or composite movements to achieve specified actions, change the position and posture of the object being grasped. The independent motion modes of the motion mechanism, such as lifting, retracting, and rotating, are called the degrees of freedom of the robotic arm.
Composition structure of plastic injection molding robot:
1. Three axis servo manipulator is mainly used to participate in the work of the assembly line, the requirements for its frequent, fast, and accurate characteristics are very high. Therefore, in terms of material design, high rigidity is mainly used, which can greatly reduce vibration and extend its service life during continuous work.
2. In order to cope with this high-frequency work, the three-axis servo robotic arm is driven by cylinders in the front, back, up, and down directions, while the arm adopts high-precision linear sliding rails. This not only makes the robotic arm stable, low noise, high efficiency, precise positioning, but also very heat-resistant, wear-resistant, and not easily deformed.
3. Large enterprises use a three-axis servo manipulator controlled by a microcomputer, which not only has a very simple operating interface, but also is very flexible in configuration. Through various configurable items above, it can be suitable for various work piece parameters on different factory production lines.
4. Three axis servo manipulator is a modular design that is very easy to move or maintain, as long as the components are removed, it can be quickly moved or repaired.
Specific inspection operation of each part of plastic injection molding robot:
1) Lubrication and maintenance of wire gauge and slide block
A. Wire gauge should be cleaned to remove dust and rust
B. Use a brush to evenly apply the lubricating oil on the wire gauge, so that the lubricating oil is not easy to accumulate.
C. Use a grease gun to inject the grease into the slider (important parts) from the slider nozzle
Hot Tags: plastic injection molding robot, China plastic injection molding robot suppliers, manufacturers, factory, High Precision Swing Arm Robots, swing arm manipulator, pneumatic robot, High Speed Swing Arm Robots, , High precision injection robot